Jump to content
EN
Play

Forum

Shaft's Sniper Mode Controls Issues


 Share

Recommended Posts

So, right to it I'm using shaft and when i move my turret while in sniper mode it goes in a grid like pattern such as up and right then down. I cannot move my turret when sniping in a smooth pattern, I cannot use shaft now because it takes too long to aim at a tank and shoot, unless if it is a titan or mammoth m0 -m1.

 

I believe that my problem is keyboard ghosting, and I have done all the steps that was recommended to me and i still face this problem. 
 

If there is such thing as another solution please, I would appreciate them.

Share this post


Link to post
Share on other sites

It happens to me too after the mouse controls update. But when I use the mouse controls I don't have any problem. So try that.

Well, I play on Chrome because I have tried other browsers and I get a severe fps drop. I have tried Firefox, IE, and Opera.

Share this post


Link to post
Share on other sites

★ Actual Problems & Solutions

 

 

 

[Copied from Actualy problems and solution topic]

 

Shaft's turret stucks and sometimes goes up when staring

Possible solution: When turret rotation jams, just press turret rotation key(Z, X & C || <, >, /) to rotate it. Crosshair is lifted after your tank gets destroyed when being aiming an opponent.
Fix is planned.

Edited by Ihajkiller

Share this post


Link to post
Share on other sites

its happening to my shaft too. bt i think devs are working hard and will fix it soon ;)

it happened months ago, they did so much changes but didnt even bother anything with it

in the months that passed, Shaft is just a dead turret to them


 

if your shaft moves to any side, press the turret to go to that side,

like, if it goes left,  press "A" or left arrow, then it will stop moving ;)

Share this post


Link to post
Share on other sites

There are two main ways to avoid keyboard ghosting:

1. Remap keys (e.g. to numpad). There still be ghosting but on non-critical combinations

2. Buy new keyboard. Ofc you should test it before.

 

Topic is old and

Closed.

Share this post


Link to post
Share on other sites

This topic is now closed to further replies.
 Share

×
×
  • Create New...